A freeze dryer is a vacuum system, a refrigeration system and a food-contact surface in one machine. This routine keeps all three healthy.
The intervals in these tables are the general framework already used on this page. Your machine's manual and our service team set the exact schedule; this page does not add thresholds or replacement intervals that the manual does not set.
| Component | Indicative interval | Check | Record | Escalate if |
|---|---|---|---|---|
| Condenser / cold trap | After every batch | Defrost and drain. Ice left on the cold trap reduces capture capacity on the next cycle and lengthens drying time. | Note that the condenser was drained | If ice remains, capture capacity falls and drying time lengthens |
| Chamber, shelves and trays | After every batch | Remove product residue with food-safe cleaners suited to 304 stainless steel, then dry fully. | Note the cleaning | Residue is a hygiene risk and can transfer odours between products |
| Door seal | After every batch | Wipe and inspect for cuts, flattening or hardening of the silicone. A crumb on the seal is enough to spoil the vacuum. | Note damage or a seal replacement | Note cuts, flattening or hardening of the silicone |
| Component | Indicative interval | Check | Record | Escalate if |
|---|---|---|---|---|
| Vacuum pump oil | Every week | Check level and colour. Cloudy or milky oil means moisture has entered the pump and the oil should be changed before it damages the pump. | Record oil changes | Change the oil when it is cloudy or milky |
| PLC cycle logs | Every week | Compare pump-down time and batch duration with earlier batches of the same product. | Keep the comparison | A slowly lengthening cycle is often the first sign of a leak or a condenser problem |
| Component | Indicative interval | Check | Record | Escalate if |
|---|---|---|---|---|
| Leak test | Every month | Pull the empty chamber down to vacuum, isolate it and record how fast pressure rises over a fixed time. Compare with the value recorded at commissioning. | Record the leak-test result | A clearly faster rise means a seal, valve or fitting needs attention |
| Temperature sensors | Every month | Check the product and shelf thermocouples against a reference thermometer. | Record the comparison | Drifting sensors lead to wrong end-of-cycle decisions |
| Refrigeration unit | Every month | Keep condenser fins and fans clean and note operating pressures. | Note operating pressures and cleaning | Note operating pressures so a technician can spot trends early |
Record oil changes, leak-test results, seal replacements and any alarms. When something goes wrong, a logbook turns a long diagnosis into a short one, and it is the first thing a service engineer will ask for.
Always follow the equipment manual. Intervals depend on running hours, product and climate. The routine above is a general framework; your machine's manual and our service team set the exact schedule.
Send the model, the alarm, the PLC records and the last intervention.
Contact